Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Upon importing your Block3D solids you will be prompted to provide Root Name, Travel Level in Tree (bench level hierarchy), Travel Alignment (top or bottom of block) and Block Type (source or destination).

...

Root Name

Each collection of blocks exists under a root name such as "OpenPit" or "Dumps". If you need to separate the properties of some blocks - for instance, paddock stack versus tip head - then they need to be under two separate root names. 

Travel Level in Tree

The Travel Level in Tree must be set to the bench level.

...

Travel Alignment

This setting determines the running level of the truck. For instance, a truck will run on the top of the block on a tip head and the bottom of the block on a paddock stack. For source blocks, trucks will generally run along the floor (bottom) unless you are top-loading.

Block Type

Designate these blocks as source or destination blocks.